Behringer B-2 Pro Review / Test

Today we're looking at a "higher end" microphone from the budget company Behringer; the Behringer B-2 Pro

For this review, I have the mic connected directly to the Focusrite Scarlett 2i2 2nd gen, with the gain set at 10:30. I have done no post processing on the audio, it is all raw, but the audio was slightly boosted in final cut pro X to simply make the audio easier to listen to.

If you are interested in this microphone, it will set you back $150.00 on Amazon

What's In the Box

  1. Hardshell Storage Box

  2. Microphone

  3. Shockmount (Includes: 5/8" & 3/8" adapter)

  4. Foam Windscreen

  5. Documentation


  1. Frequency Response: 20Hz - 20kHz

  2. Polar Pattern: Cardioid, Omnidirectional, Bidirectional

  3. Sensitivity: -37dB to -34dB

  4. Max SPL: 137 / 149dB

  5. Equivalent Noise: 16-18dBA

  6. Impedance: <100-ohms

  7. Power Requirement: +48v

Performance / Features

The build quality of this mic feels fairly average for mics in the $100 price range. It has an all metal body as well as a somewhat flimsy feeling metal mesh grill. On the front you will find a 3-way polar pattern selection switch to move between the cardioid, omnidirectional, and bi-directional polar patterns. On the rear you'll find the high-pass switch that rolls off at 6dB/octave at 150Hz, as well as a -10dB pad if you're recording loud sound sources. 

The frequency response is listed as 20Hz - 20kHz. We're only going to focus on the cardioid polar pattern response here as it's the most used pattern. It has a surprisingly flat response from 1kHz and below with a slight roll off beginning at 150Hz, which reaches -2dB by 50Hz. From 1kHz and up there's a gradual boost that hits +2dB at 7kHz, and then there's a large boost which reaches +5dB at 10kHz and gradually rolls off until it hits 0dB at 20kHz.

The overall performance here was decent. On the electric guitar, the low end felt a little loose, but did not get muddy, and then the treble air boost provided a nice amount of liveliness to the recording. The acoustic guitar sounded too focused in the high end, and left the strings resonance sounding dominating and a bit of a grating tone all around. For singing, the mic added a breathy quality to the voice as well as a bit of extra grit. For spoken word, I think the high end is a detriment to the microphone as it accentuates mouth noises, breathe, and sibilance a bit too much.


  • Relatively flat low mids and lows

  • All polar patterns are pretty usable (Rare in this price range)

  • Nice build quality

  • Plenty of nice accessories


  • Shrill in the higher end

  • Susceptible to plosives

  • Relatively high noise floor at 16-18dBA



Although this microphone would not be my first choice in any use case, for the price I think it's a pretty good deal. Therefore, if you're looking for your first mic to record music in your home studio, I think this would be a fine option given the plethora of accessories that are provided with the microphone, and the clean and clear tone you can get out of the microphone. Just make sure to pick up a pop filter along with the microphone.  

If you have any additional questions about this microphone, leave them on the youtube video, and I will try to reply ASAP. 

Buy the Behringer B-2 Pro


Buy the Focusrite Scarlett 2i2 (2nd Gen)

SFCCC: Michael Welch

If you are not familiar with the name Mike Welch, that doesn't matter. Chances are you have seen him acting in something; I can almost guarantee it. He has been acting for nearly 20 years on shows ranging from Star Trek, to Frasier, to Walker, Texas Ranger, to Stargate, to The X-Files. This guy is all over the place. 

Some of his work may not be for you, but I don't think anyone can deny that this guy's got talent. After all, he's been working for 20 years and that's something you can't accomplish if you're bad at your job. 

However, his work is not what I want to talk about. I want to talk about rejection. Michael Welch is a talented actor. But all actors, no matter how talented, will face rejection...a lot of it. At the recent Santa Fe Comic Con, I sat in on his Panel and asked how he dealt with the rejection, and here is what he said:

I realize that this is an actor talking about rejection during the audition process. However, think about how many times you have been rejected from something that you love to do. How often does that push you into a state of depression, or self doubt? Probably quite often. It's easy, it's familiar, and every single artist that I know, myself included, has gone down this road.

I have a challenge for you. Next time you are rejected, instead of feeling sorry for yourself, try to apply Mike's approach to your situation. Look at that rejection as just another opportunity to showcase your work to a new person. Another opportunity to hone your craft. Another opportunity to do what you love. Take pride in the fact that you did the absolute best that you could, and know that what you're doing is worth doing. Now go kick some ass!

Follow Michael Welch on Twitter @MichaelWelchAct
Check out SFCC: